Castability

Castability is the ease of forming a quality casting.[1] A very castable part design is easily developed, incurs minimal tooling costs, requires minimal energy, and has few rejections.[2] Castability can refer to a part design or a material property.[1]

Part design

Part design and geometry directly affect the castability, with volume, surface area and the number of features being the most important attributes.

If the design has undercuts or interior cavities it decreases castability due to tooling complexity. Long thin sections in a design are hard to fill.[1] Sudden changes in wall thickness reduce castability because it induces turbulence during filling; fillets should be added to avoid this. Annulars in the path of flow should be avoided because they can cause cold shuts or misruns. A design that causes isolated hot spots decreases castability.[3] An ideal design would have progressive directional solidification from the thinnest section to the thickest.[4]

Location of the mold's parting line also affects castability, because a non-planar parting line also increases tooling complexity.

If a design requires a high degree of accuracy, fine surface finish or defect free surface it reduces the castability of the part.[2] However, the casting process can be very economical for part designs that require intricate contoured surfaces, thickness variations, and internal features.[3]

Quantitative analysis

The castability of a design can be partially quantitatively determined by the following three equations. Better castability is denoted by a larger number.[3]

Where Vc is the volume of the casting and Vb is the volume of the smallest box that the casting could fit in.

Where Vc is the volume of the casting and Ac is the surface area of the casting

Where nf is the number of features (holes, pockets, slots, bosses, ribs, etc.)

Material properties

Material properties that influence their castability include their pouring temperature, fluidity, solidification shrinkage, and slag/dross formation tendencies.[1][5]

See also

References

Notes

  1. 1 2 3 4 Ravi, p. 1
  2. 1 2 Ravi, p. 2
  3. 1 2 3 Ravi, p. 3.
  4. Ravi, p. 4.
  5. Tool and Manufacturing Engineers Handbook (TMEH), 4th Edition, Volume 6, Design for Manufacturability, Society of Manufacturing Engineers, 1992.

Bibliography

This article is issued from Wikipedia - version of the 9/11/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.