Footplate

The footplate of a steam locomotive is a large metal plate that rests on top of the frames and is normally covered with wooden floorboards. It is usually the full width of the locomotive and extends from the front of the cab to the rear of cab or coal bunker just above the buffer beam. The boiler, the cab, and other superstructure elements are in turn mounted on the footplate. The footplate does extend beyond the front of the cab on some locomotives, but is then usually referred to as the "running board/plate." The footplate is where the Driver and Fireman stand in the cab to operate the locomotive, giving rise to the expression of working on the footplate[1] for being in the cab of a steam locomotive. The part of the footplate ahead of the cab is referred to by a variety of different names.

In the modern age, although the steam locomotive has been phased out, the word footplate remains current coin. It is used to describe the act of travelling inside the cab of a (diesel or electric) locomotive, and in this context to the cab itself also. Thus : "when the General Manager travels on a train, an engineer must be present on the footplate" or "an engineer footplated the locomotive after trouble in its bogies was reported at an intermediate station". The word however is not used to refer to the driving cab outside of context of someone riding it : the usage "the footplate of a newer WAP4 is ergonomic and very convenient for the loco pilot" is incorrect.[2] The term foot plate can also be applied to the step along the length of a classical tram on both sides.

National variations

The presence of a footplate is almost universal in British locomotive construction, is often (but not universally) seen in continental European locomotives, and practically never on locomotives constructed in the United States. American practice mounted the locomotive's boiler and cab directly on the frame.[3] The walkways and running boards seen on American locomotives that sometimes give an appearance of a footplate are attached to the boiler or the pilot and are not structural elements. The absence of a footplate on American locomotives is one thing that makes them look "not quite right" to those accustomed to the British look.

Details

The footplate has openings cut in it for various purposes. The firebox always extends beneath the footplate. The cylinders are beneath the footplate, and steam pipes pass through holes to them. The reversing gear control for the valve gear also passes through, and in some locomotives part of the valve motion also extends through the footplate.

Splashers visible on a British 0-6-0 tender locomotive (note particularly those on the second axle)

On British Railways Standard Locomotives the running plate was high enough to clear the wheels On earlier British locomotives, the tops of the wheels usually projected through slots in the running plate and were covered by "splashers" which are analogous to mudguards on a road vehicle.

See also

References

  1. ↑ "Perceptions of the locomotive driver:image and identity on British railways". York University website. 2007-03-26.
  2. ↑ "Indian Railway Videos". 1995-08-01.
  3. ↑ "The Evolution of the American Locomotive". :Scientific American Supplement—May 1, 1897 (Part 2 of 3). 2007-03-26.
This article is issued from Wikipedia - version of the 11/9/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.