Heel-and-toe

This article is about the driving technique. For the similarly named drumming technique, see Heel-toe technique.
Not to be confused with left-foot braking.
Not to be confused with double clutch (technique).

Heel-and-toe shifting[1] is a driving technique used mostly in performance driving,[2] although some drivers use it on the road in everyday conditions in the interest of effectiveness. It involves operating the throttle and brake pedals simultaneously with the right foot, while facilitating normal activation of the clutch with the left foot. It is used when braking and downshifting simultaneously (prior to entering a turn), and allows the driver to "blip" the throttle to raise the engine speed and smoothly engage the lower gear. (See Synchronized transmission.)

Usage

Heel-and-toe shifting is used before entry into a turn while a vehicle is under braking, preparing the transmission to be in the optimal range of rpm to accelerate out of the turn. One benefit of downshifting before entering a turn is to eliminate the jolt to the drivetrain, or any other unwanted dynamics. The jolt will not upset the vehicle as badly when going in a straight line, but the same jolt while turning may upset the vehicle enough to cause loss of control if it occurs after the turn has begun. Sporting vehicles are usually modified (if necessary) so that the heights of the brake and accelerator pedals are closely matched when the brake is sufficiently depressed, and the pedals are not too far apart to permit easy use of heel-and-toe.

The name stems from pre-WW2 vehicles where the accelerator pedal was in the centre (between the clutch on the left and the foot brake to the right). The brake was able to be operated with the heel whilst the accelerator pedal could be simultaneously pressed with the toe. The technique is carried out in modern cars by operating the brake with the toe area, while rocking the foot across to the right to operate the throttle with the right side of the foot. With practice, it becomes possible to smoothly and independently operate both pedals with one foot. The technique is common in all forms of motorsports.

As the power band of most race cars remains high throughout the rev range, this technique can also be used to ensure that engine rpm does not drop below the power band of the car while under braking. If this happened there would be a delay between the driver accelerating after the corner and when the car responds; this is especially true in turbocharged cars. This technique ensures that maximum power can be reached the instant the brake pedal is released and the accelerator fully depressed.

Rowing is the technique of downshifting more than one gear along with the heel-and-toe technique to provide engine braking and smoother deceleration/braking while in the intermediate gears . This provides for maximum braking when going from a top gear to a much lower gear, and optimal engine RPM for exiting the corner.

Note

An unrelated technique called left-foot braking should not be confused with heel-and-toe. An unrelated technique called double clutch should not be confused with heel-and-toe.

References

  1. ↑ https://www.youtube.com/watch?v=VxGtx9xXhlM youtube.com Hooked On Driving channel's explanatory video
  2. ↑ www.nasaproracing.com

External links

This article is issued from Wikipedia - version of the 11/29/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.