Homodyne detection
Homodyne detection is a method of detecting frequency-modulated radiation by non-linear mixing with radiation of a reference frequency, the same principle as for heterodyne detection.
In optics
In optical interferometry, homodyne signifies that the reference radiation (i.e. the local oscillator) is derived from the same source as the signal before the modulating process. For example, in a laser scattering measurement, the laser beam is split into two parts. One is the local oscillator and the other is sent to the system to be probed. The scattered light is then mixed with the local oscillator on the detector. This arrangement has the advantage of being insensitive to fluctuations in the frequency of the laser. Usually the scattered beam will be weak, in which case the (nearly) steady component of the detector output is a good measure of the instantaneous local oscillator intensity and therefore can be used to compensate for any fluctuations in the intensity of the laser.
Radio technology
In radio technology, the distinction is not the source of the local oscillator, but the frequency used. In heterodyne detection, the local oscillator is frequency-shifted, while in homodyne detection it has the same frequency as the radiation to be detected. See direct conversion receiver.
Applications
Homodyne and heterodyne techniques are commonly used in thermoreflectance techniques.
Homodyne detection was one of the key techniques in demonstrating spooky action at a distance.[1]
See also
References
- ↑ Maria Fuwa; Shuntaro Takeda; Marcin Zwierz; Howard M. Wiseman; Akira Furusawa (24 March 2015). "Experimental proof of nonlocal wavefunction collapse for a single particle using homodyne measurements". Nature Communications. 6 (6665): 6665. arXiv:1412.7790
. Bibcode:2015NatCo...6E6665F. doi:10.1038/ncomms7665.