Problems in coal mining

If the coal seam reaches a fault, the seam may be significantly displaced, depending on the type of fault and its offset. Machinery trying to mine the coal may not be able to reach the displaced seam, if the displacement is too large. Coal mines use a combination of boreholes and high-resolution seismic reflection data to identify the larger faults and avoid the most faulted areas at the mine planning stage.[1]

Water table


If the water table is too high, the mine will flood with water. While mining, water needs to be constantly pumped out and this is expensive.

Washout

See also: Washout

If a distributary or river changes course and cuts into the swamp material that will form coal, the coal seam is not fully formed and there may be a problem with mining it.

Thickness of seams


If the seams are too thin it may be uneconomical to mine the coal. The cost of production could exceed the selling price.

Splitting of seams


If the seam splits, due to a delta collapsing, sand and silt sediments pile up on top until that area is covered. This may make all or part of the coal seam uneconomical to mine as it is too thin.

References

  1. Cocker, J.; Urosevic, M.; Evans, B. (1997). "A High Resolution Seismic Survey to Assist in Mine Planning". In Gubins A.G. Proceedings of Exploration 97: Fourth Decennial International Conference on Mineral Exploration (PDF). pp. 473–476. Retrieved 2009-11-17.


This article is issued from Wikipedia - version of the 7/16/2015. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.