Bulk modulus

Illustration of uniform compression

The bulk modulus ( or ) of a substance is a measure of how compressible that substance is. It is defined as the ratio of the infinitesimal pressure increase to the resulting relative decrease of the volume.[1]

Definition

The bulk modulus can be formally defined by the equation

where is pressure, is volume, and denotes the derivative of pressure with respect to volume. Equivalently

where ρ is density and dP/dρ denotes the derivative of pressure with respect to density (i.e. pressure rate of change with volume). The inverse of the bulk modulus gives a substance's compressibility.

Other moduli describe the material's response (strain) to other kinds of stress: the shear modulus describes the response to shear, and Young's modulus describes the response to linear stress. For a fluid, only the bulk modulus is meaningful. For an anisotropic solid such as wood or paper, these three moduli do not contain enough information to describe its behaviour, and one must use the full generalized Hooke's law.

Thermodynamic relation

Strictly speaking, the bulk modulus is a thermodynamic quantity, and in order to specify a bulk modulus it is necessary to specify how the temperature varies during compression: constant-temperature (isothermal ), constant-entropy (isentropic ), and other variations are possible. Such distinctions are especially relevant for gases.

For an ideal gas, the isentropic bulk modulus is given by

and the isothermal bulk modulus is given by

where

γ is the heat capacity ratio
p is the pressure.

When the gas is not ideal, these equations give only an approximation of the bulk modulus. In a fluid, the bulk modulus K and the density ρ determine the speed of sound c (pressure waves), according to the Newton-Laplace formula

In solids, and have very similar values. Solids can also sustain transverse waves: for these materials one additional elastic modulus, for example the shear modulus, is needed to determine wave speeds.

Measurement

It is possible to measure the bulk modulus using powder diffraction under applied pressure. It is a property of a fluid which shows its ability to change its volume under its pressure.

Selected values

Approximate bulk modulus (K) for common materials
Material Bulk modulus in GPa Bulk modulus in psi
Glass (see also diagram below table) 35 to 55 5.8×106
Steel 160 23.2×106
Diamond (at 4K) [2] 443 64×106
Influences of selected glass component additions on the bulk modulus of a specific base glass.[3]

A material with a bulk modulus of 35 GPa loses one percent of its volume when subjected to an external pressure of 0.35 GPa (~3500 bar).

Approximate bulk modulus (K) for other substances
Water 2.2×109 Pa (value increases at higher pressures)
Methanol 8.23×108 Pa (at 20 °C and 1 Atm)
Air 1.42×105 Pa (adiabatic bulk modulus)
Air 1.01×105 Pa (constant temperature bulk modulus)
Solid helium 5×107 Pa (approximate)

References

  1. "Bulk Elastic Properties". hyperphysics. Georgia State University.
  2. Page 52 of "Introduction to Solid State Physics, 8th edition" by Charles Kittel, 2005, ISBN 0-471-41526-X
  3. Fluegel, Alexander. "Bulk modulus calculation of glasses". glassproperties.com.

Further reading

Conversion formulas
Homogeneous isotropic linear elastic materials have their elastic properties uniquely determined by any two moduli among these; thus, given any two, any other of the elastic moduli can be calculated according to these formulas.
Notes


There are two valid solutions.
The plus sign leads to .
The minus sign leads to .

Cannot be used when
This article is issued from Wikipedia - version of the 10/31/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.