Distorted thread locknut

A distorted thread locknut,[1] is a type of locknut that uses a deformed section of thread to keep the nut from loosening from vibrations or rotation of the clamped item. They are broken down into four types: elliptical offset nuts, centerlock nuts, toplock nuts and partially depitched (Philidas) nuts.

High temperature use

Because these nuts are solid metal, they are effective in elevated temperature settings, unlike nyloc nuts. High grade nuts are good up to 1,400 °F (760 °C).

Safety factors

High strength distorted thread nuts cannot be used with low strength fasteners because the hard nut will act like a die and destroy the threads on the fastener.[2]

Elliptical offset nuts

Elliptical offset nuts is a catch-all category that encompasses designs known as oval locknuts[1] or non-slotted hex locknuts,.[3] The salient feature is that the threadform has been deformed at one end so that the threads are no longer perfectly circular. The deformed end is usually shaped into an ellipse or obround triangle. These are known as one-way nuts as the nut may be easily started on the male fastener from the bottom non-deformed portion, but are practically impossible to start from the deformed end. As the male fastener reaches the deformed section it stretches the threads of the nut elastically back into a circle. This action increases the friction between the nut and the fastener greatly and creates the locking action. Due to the elastic nature of the deformation the nuts can be reused indefinitely.[2]

Centerlock nuts

Center lock nuts are similar to elliptical offset nuts, except that they are distorted in the middle of the nut. This allows the nut to be started from either side.[1]

Toplock nuts

Toplock nuts are also similar to elliptical offset nuts, except that the whole thread on one end is not distorted. Instead only three small sections of the thread are deformed on one end.[1]

Partially depitched nuts

Partially depitched nuts are commonly called Philidas nuts,[4] after their originator and current manufacturer, and differ from the above three nut types insofar as a portion of the thread is displaced axially, this being facilitated by one or more slots perpendicular to the axis.

See also

References

Notes

  1. 1 2 3 4 McMaster, p. 3139.
  2. 1 2 Smith, pp. 104–105.
  3. ↑ Non-slotted hex locknut, retrieved 2008-11-30.
  4. ↑ Philidas nut, retrieved 2012-12-01.

Bibliography

This article is issued from Wikipedia - version of the 9/23/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.