Marker-assisted selection

Marker assisted selection or marker aided selection (MAS) is an indirect selection process where a trait of interest is selected based on a marker (morphological, biochemical or DNA/RNA variation) linked to a trait of interest (e.g. productivity, disease resistance, abiotic stress tolerance, and quality), rather than on the trait itself.[1][2][3][4] This process is used in plant and animal breeding.

For example, using MAS to select individuals with disease resistance involves identifying a marker allele that is linked with disease resistance rather than the level of disease resistance. The assumption is that the marker associates at high frequency with the gene or quantitative trait locus (QTL) of interest, due to genetic linkage (close proximity, on the chromosome, of the marker locus and the disease resistance-determining locus). MAS can be useful to select for traits that are difficult or expensive to measure, exhibit low heritability and/or are expressed late in development. At certain points in the breeding process the specimens are examined to ensure that they express the desired trait.

Marker types

The majority of MAS work in the present era uses DNA-based markers. However, the first markers that allowed indirect selection of a trait of interest were morphological markers. In 1923, Sax first reported association of a simply inherited genetic marker with a quantitative trait in plants when he observed segregation of seed size associated with segregation for a seed coat color marker in beans (Phaseolus vulgaris L. ). In 1935, Rasmusson demonstrated linkage of flowering time (a quantitative trait) in peas with a simply inherited gene for flower color.

Markers may be:

Positive and negative selectable markers

The following terms are generally less relevant to discussions of MAS in plant and animal breeding, but are highly relevant in molecular biology research:

A distinction can be made between selectable markers (which eliminate certain genotypes from the population) and screenable markers (which cause certain genotypes to be readily identifiable, at which point the experimenter must "score" or evaluate the population and act to retain the preferred genotypes). Most MAS uses screenable markers rather than selectable markers.

Gene vs marker

The gene of interest directly causes production of protein(s) or RNA that produce a desired trait or phenotype, whereas markers (a DNA sequence or the morphological or biochemical markers produced due to that DNA) are genetically linked to the gene of interest. The gene of interest and the marker tend to move together during segregation of gametes due to their proximity on the same chromosome and concomitant reduction in recombination (chromosome crossover events) between the marker and gene of interest. For some traits, the gene of interest has been discovered and the presence of desirable alleles can be directly assayed with a high level of confidence. However, if the gene of interest is not known, markers linked to the gene of interest can still be used to select for individuals with desirable alleles of the gene of interest. When markers are used there may be some inaccurate results due to inaccurate tests for the marker. There also can be false positive results when markers are used, due to recombination between the marker of interest and gene (or QTL). A perfect marker would elicit no false positive results. The term 'perfect marker' is sometimes used when tests are performed to detect a SNP or other DNA polymorphism in the gene of interest, if that SNP or other polymorphism is the direct cause of the trait of interest. The term 'marker' is still appropriate to use when directly assaying the gene of interest, because the test of genotype is an indirect test of the trait or phenotype of interest.

Important properties of ideal markers for MAS

An ideal marker:

Demerits of morphological markers

Morphological markers are associated with several general deficits that reduce their usefulness including:

To avoid problems specific to morphological markers, the DNA-based markers have been developed. They are highly polymorphic, exhibit simple inheritance (often codomimant), are abundant throughout the genome, are easy and fast to detect, exhibit minimum pleiotropic effects, and detection is not dependent on the developmental stage of the organism. Numerous markers have been mapped to different chromosomes in several crops including rice, wheat, maize, soybean and several others, and in livestock such as cattle, pigs and chickens. Those markers have been used in diversity analysis, parentage detection, DNA fingerprinting, and prediction of hybrid performance. Molecular markers are useful in indirect selection processes, enabling manual selection of individuals for further propagation.

Selection for major genes linked to markers

'Major genes' that are responsible for economically important characteristics are frequent in the plant kingdom. Such characteristics include disease resistance, male sterility,[7] self-incompatibility, and others related to shape, color, and architecture of whole plants and are often of mono- or oligogenic in nature. The marker loci that are tightly linked to major genes can be used for selection and are sometimes more efficient than direct selection for the target gene. Such advantages in efficiency may be due for example, to higher expression of the marker mRNA in such cases that the marker is actually a gene. Alternatively, in such cases that the target gene of interest differs between two alleles by a difficult-to-detect single nucleotide polymorphism, an external marker (be it another gene or a polymorphism that is easier to detect, such as a short tandem repeat) may present as the most realistic option.

Situations that are favorable for molecular marker selection

There are several indications for the use of molecular markers in the selection of a genetic trait.

In such situations that:

The cost of genotyping (an example of a molecular marker assay) is reducing while the cost of phenotyping is increasing particularly in developed countries thus increasing the attractiveness of MAS as the development of the technology continues.

Steps for MAS

Generally the first step is to map the gene or quantitative trait locus (QTL) of interest first by using different techniques and then using this information for marker assisted selection. Generally, the markers to be used should be close to gene of interest (<5 recombination unit or cM) in order to ensure that only minor fraction of the selected individuals will be recombinants. Generally, not only a single marker but rather two markers are used in order to reduce the chances of an error due to homologous recombination. For example, if two flanking markers are used at same time with an interval between them of approximately 20cM, there is higher probability (99%) for recovery of the target gene.

QTL mapping techniques

In plants QTL mapping is generally achieved using bi-parental cross populations; a cross between two parents which have a contrasting phenotype for the trait of interest are developed. Commonly used populations are recombinant inbred lines (RILs), doubled haploids (DH), back cross and F2. Linkage between the phenotype and markers which have already been mapped is tested in these populations in order to determine the position of the QTL. Such techniques are based on linkage and are therefore referred to as "linkage mapping".A

Single step MAS and QTL mapping

In contrast to two-step QTL mapping and MAS, a single-step method for breeding typical plant populations has been developed.[8][9]

In such an approach, in the first few breeding cycles, markers linked to the trait of interest are identified by QTL mapping and later the same information is used in the same population. In this approach, pedigree structure is created from families that are created by crossing number of parents (in three-way or four way crosses). Both phenotyping and genotyping is done using molecular markers mapped the possible location of QTL of interest. This will identify markers and their favorable alleles. Once these favorable marker alleles are identified, the frequency of such alleles will be increased and response to marker assisted selection is estimated. Marker allele(s) with desirable effect will be further used in next selection cycle or other experiments.

High-throughput genotyping techniques

Recently high-throughput genotyping techniques are developed which allows marker aided screening of many genotypes. This will help breeders in shifting traditional breeding to marker aided selection. One example of such automation is using DNA isolation robots, capillary electrophoresis and pipetting robots.

One recent example of capllilary system is Applied Biosystems 3130 Genetic Analyzer. This is the latest generation of 4-capillary electrophoresis instruments for the low to medium throughput laboratories.

Use of MAS for backcross breeding

A minimum of five or six-backcross generations are required to transfer a gene of interest from a donor (may not be adapted) to a recipient (recurrent – adapted cultivar). The recovery of the recurrent genotype can be accelerated with the use of molecular markers. If the F1 is heterozygous for the marker locus, individuals with the recurrent parent allele(s) at the marker locus in first or subsequent backcross generations will also carry a chromosome tagged by the marker.

Marker assisted gene pyramiding

Gene pyramiding has been proposed and applied to enhance resistance to disease and insects by selecting for two or more than two genes at a time. For example in rice such pyramids have been developed against bacterial blight and blast. The advantage of use of markers in this case allows to select for QTL-allele-linked markers that have same phenotypic effect.

ABI 3130 genetic analyzer.

MAS has also been proved useful for livestock improvement.[10]

A coordinated effort to implement wheat (Triticum turgidum and Triticum aestivum) marker assisted selection in the U.S. as well as a resource for marker assisted selection exists at the Wheat CAP (Coordinated Agricultural Project) website. Farhad Kahani

Marker Assisted Selection Learning Lessons

See also


  1. review MAS in plant breeding
  2. Ribaut, J.-M. et al., Genetic basis of physiological traits. In Application of Physiology in Wheat Breeding, CIMMYT, Mexico, 2001.
  3. Ribaut, J.-M. and Hoisington, D. A., Marker assisted selection: new tools and strategies. Trends Plant Sci., 1998, 3, 236–239.
  4. Rosyara, U.R. 2006. REQUIREMENT OF ROBUST MOLECULAR MARKER TECHNOLOGY FOR PLANT BREEDING APPLICATIONS.Journal of Plant Breed. Gr. 1: 67 – 72. click to download
  5. "positive selection". Scitable. Nature. Retrieved 29 September 2011.
  6. "negative selection". Scitable. Nature. Retrieved 29 September 2011.
  7. Nowicki, Marcin; et al. (26 October 2013), More than meets the eye: A multi-year expressivity analyses of tomato sterility in ps and ps-2 lines (PDF), Australian Journal of Crop Science, 7(13):2154-2161; Southern Cross Publishing, retrieved 2013-10-29
  8. Rosyara, U. R.; K.L. Maxson-Stein; K.D. Glover; J.M. Stein; J.L. Gonzalez-Hernandez. 2007. Family-based mapping of FHB resistance QTLs in hexaploid wheat. Proceedings of National Fusarium head blight forum, 2007, Dec 2-4, Kansas City, MO.
  9. Rosyara U.R., J.L. Gonzalez-Hernandez, K.D. Glover, K.R. Gedye and J.M. Stein. 2009. Family-based mapping of quantitative trait loci in plant breeding populations with resistance to Fusarium head blight in wheat as an illustration Theoretical Applied Genetics 118:1617-1631
  10. Dekkers., J. C. M. 2004. Commercial application of marker- and gene-assisted selection in livestock: Strategies and lessons. J. Anim. Sci. 82:E313-E328.

Further reading

This article is issued from Wikipedia - version of the 10/15/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.