Thin-skinned deformation

An example of Thin-skinned thrusting in Montana. Note the white Madison Formation limestone repeated, with one example in the foreground (that pinches out with distance) and another to the upper right corner and top of the picture.

Thin-skinned deformation is a style of deformation in plate tectonics at a convergent boundary which occurs with shallow thrust faults that only involves cover rocks (typically sedimentary rocks), and not deeper basement rocks.[1]

The thin-skinned style of deformation is typical of many fold and thrust belts developed in the foreland of a collisional zone or back arc of a continental volcanic arc. This is particularly the case where a good basal decollement exists, usually in a weaker layer like a shale, evaporite, or a zone of high pore fluid pressure.[2] This was first described in Rocky Mountains of the United States, as part of the Sevier Orogeny.

In the rock record, this will increase the influence of more surficial rocks, which usually includes sedimentary rocks. Typically, you will see repeated sections of the same rock over and over as thrust faults, coming up from the decollement, stack the same layer on top of itself. The sediments that are created by this type of deformation are typically lithic sandstones.

See also

References

  1. ↑ Davidson et al., 1997, Exploring Earth, An Introduction to Physical Geology, ISBN 0-13-463936-7
  2. ↑ Hatcher, R.D. 2007. Confirmation of Thin-skinned Thrust Faulting in Foreland Fold-Thrust Belts and Its Impact on Hydrocarbon Exploration: Bally, Gordy, and Stewart, Bulletin of Canadian Petroleum Geology, 1966. First in the AAPG History of Petroleum Geology Series on Papers Having a Major Impact on Petroleum Geology: A contribution of the AAPG History of Petroleum Geology Committee


This article is issued from Wikipedia - version of the 6/30/2010. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.