Core War

Core War

A game of Core War running under the pMARS simulator
Original author(s) D. G. Jones & A. K. Dewdney
Initial release 1984
Type Programming game

Core War is a programming game created by D. G. Jones and A. K. Dewdney in which two or more battle programs (called "warriors") compete for control of a virtual computer. These battle programs are written in an abstract assembly language called Redcode.

At the beginning of a game, each battle program is loaded into memory at a random location, after which each program executes one instruction in turn. The object of the game is to cause the processes of opposing programs to terminate (which happens if they execute an invalid instruction), leaving the victorious program in sole possession of the machine.

Gameplay

Key features

Relatively few instructions
The earliest published version of Redcode defined only 8 instructions. The ICWS-86 standard increased the number to 10 while the ICWS-88 standard increased it to 11. The currently used ICWS-94 standard has 16 instructions. However, Redcode supports a number of different addressing modes and (from ICWS-94) instruction modifiers which increase the actual number of operations possible to 7168. The Redcode standard leaves the underlying instruction representation undefined and provides no means for programs to access it. Arithmetic operations may be done on the two address fields contained in each instruction, but the only operations supported on the instruction codes themselves are copying and comparing for equality.
Constant instruction length and time
Each Redcode instruction occupies exactly one memory slot and takes exactly one cycle to execute. The rate at which a process executes instructions, however, depends on the number of other processes in the queue, as processing time is shared equally.
Circular memory
The memory is addressed in units of one instruction. The memory space (or core) is of finite size, but only relative addressing is used, that is, address 0 always refers to the currently executing instruction, address 1 to the instruction after it, and so on. The maximum address value is set to equal one less than the number of memory locations, and will wrap around if necessary. As a result, there is a one-to-one correspondence between addresses and memory locations, but it is impossible for a Redcode program to determine any absolute address. A process that encounters no invalid or jump instructions will continue executing successive instructions endlessly, eventually returning to the instruction where it started.
Low level multiprocessing
Instead of a single instruction pointer a Redcode simulator has a process queue for each program containing a variable number of instruction pointers which the simulator cycles through. Each program starts with only one process, but new processes may be added to the queue using the SPL instruction. A process dies when it executes a DAT instruction or performs a division by zero. A program is considered dead when it has no more processes left.
No external access
Redcode and the MARS architecture provide no input or output functions. The simulator is a closed system, with the only input being the initial values of the memory and the process queues, and the only output being the outcome of the battle, i.e., which programs had surviving processes. Of course, the simulator may still allow external inspection and modification of the memory while the simulation is running.

Versions of Redcode

A number of versions of Redcode exist. The earliest version described by A. K. Dewdney[1] differs in many respects from the later standards established by the International Core War Society, and could be considered a different, albeit related, language. The form of Redcode most commonly used today is based on a draft standard submitted to the ICWS in 1994 that was never formally accepted, as the ICWS had become effectively defunct around that time. Development of Redcode, however, has continued in an informal manner, chiefly via online forums such as the rec.games.corewar[2] newsgroup.

Strategy

Warriors are commonly divided into a number of broad categories, although actual warriors may often combine the behavior of two or more of these. Three of the common strategies (replicator, scanner and bomber) are also known as paper, scissors and stone, since their performance against each other approximates that of their namesakes in the well-known playground game.[3]

Paper (or replicator)
A replicator makes repeated copies of itself and executes them in parallel, eventually filling the entire core with copies of its code. Replicators are hard to kill, but often have difficulty killing their opponents. Replicators therefore tend to score a lot of ties, particularly against other replicators.
A silk is a special type of very rapid replicator, named after Silk Warrior[4] by Juha Pohjalainen. Most modern replicators are of this type. Silk replicators use parallel execution to copy their entire code with one instruction, and begin execution of the copy before it is finished.[5]
Scissors (or scanner)
A scanner is designed to beat replicators. A scanner does not attack blindly, but tries to locate its enemy before launching a targeted attack. This makes it more effective against hard-to-kill opponents like replicators, but also leaves it vulnerable to decoys. A scanner usually bombs memory with SPL 0 instructions. This causes the enemy to create a huge number of processes which do nothing but create more processes, slowing down useful processes. When the enemy becomes so slow that it is unable to do anything useful, the memory is bombed with DAT instructions. Scanners are also generally more complex, and therefore larger and more fragile, than other types of warriors.[6]
A one-shot is a very simple scanner that only scans the core until it finds the first target, and then permanently switches to an attack strategy, usually a core clear. Myrmidon[7] by Roy van Rijn is an example of a oneshot.
Stone (or bomber)
A bomber blindly copies a "bomb" at regular intervals in the core, hoping to hit the enemy. The bomb is often a DAT instruction, although other instructions, or even multi-instruction bombs, may be used. A bomber can be small and fast, and they gain an extra edge over scanning opponents since the bombs also serve as convenient distractions. Bombers are often combined with imp spirals to gain extra resiliency against replicators.
Vampire (or pit-trapper)
A vampire tries to make its opponent's processes jump into a piece of its own code called a "pit". Vampires can be based on either bombers or scanners. A major weakness of vampires is that they can be easily attacked indirectly, since they must by necessity scatter pointers to their code all over the core. Their attacks are also slow, as it takes an extra round for the processes to reach the pit. myVamp[8] by Paulsson is an example of a vampire.
Imp
Imps are named after the first ever published warrior, Imp[9] by A. K. Dewdney, a trivial one-instruction mobile warrior that continually copies its sole instruction just ahead of its instruction pointer. Imps are hard to kill but next to useless for offense. Their use lies in the fact that they can easily be spawned in large numbers, and may survive even if the rest of the warrior is killed.
An imp ring (or imp spiral) consists of imps spaced at equal intervals around the core and executing alternately. The imps at each arm of the ring/spiral copy their instruction to the next arm, where it is immediately executed again. Rings and spirals are even harder to kill than simple imps, and they even have a (small) chance of killing warriors not protected against them. The number of arms in an imp ring or spiral must be relatively prime with the size of the core.
Quickscanner (or q-scan)
A quickscanner attempts to catch its opponent early by using a very fast unrolled scanning loop. Quickscanning is an early-game strategy, and always requires some other strategy as a backup. Adding a quickscanning component to a warrior can improve its score against long warriors such as other quickscanners. However, the unrolled scan can only target a limited number of locations, and is unlikely to catch a small opponent.
Core clear
A core clear sequentially overwrites every instruction in the core, sometimes even including itself. Core clears are not very common as stand-alone warriors, but are often used as an end-game strategy by bombers and scanners.

Core War Programming

With an understanding of Core War strategies, a programmer can create a warrior to achieve certain goals. Revolutionary ideas come once in a while; most of the time, however, programmers base their programs on already published warriors. Using optimizers such as OptiMax or core-step optimizer tools, a more effective warrior can be created.

Warriors can also be generated by genetic algorithms or genetic programming. Programs that integrate this evolutionary technique are known as evolvers. Several evolvers were introduced by the Core War community and tend to focus on generating warriors for smaller core settings. The latest evolver with significant success was µGP[10] which produced some of the most successful nano and tiny warriors. Nevertheless, evolutionary strategy still needs to prove its effectiveness on larger core settings.[11]

Development

Core War was inspired by a self-replicating program called Creeper and a subsequent program called Reaper that destroyed copies of Creeper.[12] Creeper was created by Bob Thomas at BBN.[13] Dewdney was not aware of the origin of Creeper and Reaper and refers to them as a rumor originating from Darwin and the worm experiments of Shoch and Hupp. The 1984 Scientific American article on Core War[12] nevertheless cites the game Darwin, played by Victor A. Vyssotsky, Robert Morris, and Douglas McIlroy at Bell Labs in 1961. The word "Core" in the name comes from magnetic-core memory, an obsolete random-access memory technology.

The first description of the Redcode language was published in March 1984, in Core War Guidelines by D. G. Jones and A. K. Dewdney.[1] The game was introduced to the public in May 1984, in an article written by Dewdney in Scientific American. Dewdney revisited Core War in his "Computer Recreations" column in March 1985,[14] and again in January 1987.[15]

The International Core Wars Society (ICWS) was founded in 1985, one year after Dewdney's original article. The ICWS published new standards for the Redcode language in 1986 and 1988, and proposed an update in 1994 that was never formally set as the new standard.[16] Nonetheless, the 1994 draft was commonly adopted and extended, and forms the basis of the de facto standard for Redcode today. The ICWS was directed by Mark Clarkson (1985–1987), William R. Buckley (1987–1992), and Jon Newman (1992–); currently the ICWS is defunct.[17]

Redcode

 0000:  ADD.AB  #   4, $   3
 0001:  MOV.F   $   2, @   2
 0002:  JMP.B   $  -2, $   0
 0003:  DAT.F   #   0, #   0
Assembled ICWS-94 style Redcode

Redcode is the programming language used in Core War. It is executed by a virtual machine known as a Memory Array Redcode Simulator, or MARS. The design of Redcode is loosely based on actual CISC assembly languages of the early 1980s, but contains several features not usually found in actual computer systems.

Both Redcode and the MARS environment are designed to provide a simple and abstract platform without the complexity of actual computers and processors. Although Redcode is meant to resemble an ordinary CISC assembly language, it differs in many ways from "real" assembly.

References

  1. 1 2 Jones, D. G.; Dewdney, A. K. (March 1984). "Core War Guidelines". Retrieved 2013-03-11.
  2. ↑ "rec.games.corewar on Google Groups". Retrieved 2013-03-11.
  3. ↑ Wangsaw, Mintardjo. "Intro to Art in '88: Paper - Stone - Scissors Trilogy". Retrieved 2013-03-11.
  4. ↑ Pohjalainen, Jippo. "Silk Warrior 1.3". Retrieved 2013-03-11.
  5. ↑ Pohjalainen, Jippo (April 1995). "Replicators? - Phoenix & TimeScape source". Retrieved 2013-03-11.
  6. ↑ Metcalf, John (April 2004). "Anatomy of the Scanner, A Basic Introduction". Retrieved 2013-03-11.
  7. ↑ van Rijn, Roy. "Myrmidon". Retrieved 2013-03-11.
  8. ↑ Paulsson, Magnus. "myVamp v3.7". Retrieved 2013-03-11.
  9. ↑ Dewdney, A. K. "Imp". Retrieved 2013-03-11.
  10. ↑ Squillero, Giovanni. "µGP (MicroGP)". Retrieved 2016-02-20.
  11. ↑ Vowk, Barkley; Wait, Alexander; Schmidt, Christian. "An Evolutionary Approach Generates Human Competitive Corewar Programs" (PDF). Retrieved 2013-03-11.
  12. 1 2 Dewdney, A. K. (May 1984). "In the game called Core War hostile programs engage in a battle of bits.". Scientific American. Retrieved 2008-11-18.
  13. ↑ Shoch, J.; Hupp, J. (March 1982). "The 'Worm' Programs - Early Experience with a Distributed Computation". Communications of the ACM. 25 (3): 172–180. doi:10.1145/358453.358455.
  14. ↑ Dewdney, A. K. (March 1985). "A Core War bestiary of viruses, worms and other threats to computer memories.". Scientific American. Retrieved 2008-11-18.
  15. ↑ Dewdney, A. K. (January 1987). "A program called MICE nibbles its way to victory at the first Core War tournament.". Scientific American. Retrieved 2008-11-18.
  16. ↑ Doligez, Damien; Durham, Mark (8 November 1995). "Annotated Draft of the Proposed 1994 Core War Standard". Retrieved 2013-03-11.
  17. ↑ Metcalf, John. "A Brief History of Corewar". Retrieved 2013-03-11.

External links

This article is issued from Wikipedia - version of the 10/5/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.