PRR B6

Pennsylvania Railroad B6

PRR No. 1670 at the Railroad Museum of Pennsylvania in 2010
Type and origin
Power type Steam
Builder
Build date 1902–1912 (B6)
1912–1913 (B6sa)
1916–1920 (B6sb)
Total produced B6: 79;
B6sa: 55;
B6sb: 238
Specifications
Configuration 0-6-0
UIC class C (B6) Ch (B6s/B6sa/B6sb)
Gauge 4 ft 8 12 in (1,435 mm) standard gauge
Driver dia. 56 in (1.422 m)
Wheelbase locomotive: 11 ft 6 in (3.51 m)
Fuel type Coal
Boiler pressure 205 psi (1.41 MPa)
Cylinders Two
Cylinder size 22 in × 24 in (559 mm × 610 mm)
Valve gear B6: Stephenson;
B6sa/B6sb: Walschaerts
Valve type Piston valves
Performance figures
Tractive effort 36,144 lbf (160.8 kN)
Career
Preserved Nos. 60 (B6sa) and 1670 (B6sb)
Disposition Two preserved, remainder scrapped

The Pennsylvania Railroad's class B6 was its most successful class of switcher, or as the PRR termed them, "shifter". The PRR preferred the 0-6-0 wheel arrangement for larger switchers, whereas on other roads the 0-8-0 gained preference. The PRR used road locomotives, generally 2-8-0s, when larger power was required.

History

Altoona Works constructed the prototype B6 in 1902. The B6 had the Pennsylvania's trademark square-shouldered Belpaire firebox and 56-inch (1.422 m) drivers. They were constructed as saturated steam engines, rebuilt with superheaters later as class B6s, and had Piston valves and Stephenson valve gear. A total of 79 were built by Baldwin and Lima, in addition to Altoona, between 1902–1913.[1]

The next version built was the B6sa, 55 of which were built at Altoona during 19131914. These had radial-stay fireboxes, common elsewhere but rare on the Pennsylvania, and they replaced the Stephenson gear with the more modern Walschaerts valve gear. Steam delivery pipes were outside, like all other PRR modern power. All were built superheated.

Finally, during 19161920, 238 of class B6sb were built. These were the final, definitive type, and had a Belpaire firebox, but were otherwise little changed from the B6sa. The final 97 locomotives had piston valves mounted outboard of the cylinders, instead of inbound as previously built, giving the cylinder assemblies an outward cant at the top, rather than inward.

All B6sa and B6sb locomotives were retrofitted with power reverse to make the frequent back-and-forth of switching quicker and easier.

The last PRR locomotive in active service was #5244, leased to Union Transportation of New Egypt, New Jersey until July 1959.

Two B6 survive, B6sb #1670 was saved in the PRR's historic collection at Northumberland, Pennsylvania and was donated to the Railroad Museum of Pennsylvania along with the majority of that collection.

B6sa #60 is on a siding in Hockessin, Delaware, along the Wilmington and Western Railroad. It has a larger tender, from a 2-8-0 Consolidation, but it is intact, albeit in poor condition.

Notes

References

This article is issued from Wikipedia - version of the 8/1/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.