Punch in/out

Punch in/out is a recording technique used on early multitrack recordings whereby a portion of the performance was overdubbed onto a previously recorded tape, usually overwriting any sound that had previously been on the track used.[1] The erasing and/or recording heads had to be very carefully aligned and applied to the tape surface with delicate timing and precision to avoid ruining the recording, and the practice was feared by most producers and engineers.

After the advent of 16 and 24 track equipment it was no longer necessary to risk the recording as a whole, as an empty portion of another track could be dedicated to such use. Vocalists in particular would usually record several renditions over separate parallel tracks, with the producers choosing the best bits from the layered vocals to mix together. The term "punching in" remained in use despite this fact.

Usage in digital recording

In modern, Digital Audio Workstation-based recording environments, punching in and out can be done automatically by pre-selecting the in and out points on the timeline of the DAW. When the record button is pressed, the DAW software will play back the previously recorded track outside of these points. As soon as the playhead reaches the in-point, the recording begins and the previously recorded material is muted. At the out-point, recording stops and the software reverts to playback.

See also


  1. Pandey, Ashish (2005). Encyclopaedic Dictionary of Music: K-Z, p.551. Gyan. ISBN 9788182052017.
This article is issued from Wikipedia - version of the 10/15/2015. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.