USS Albacore (AGSS-569)

For other ships with the same name, see USS Albacore.
USS Albacore off the coast of Rhode Island
History
United States
Name: Albacore
Namesake: Albacore
Ordered: 24 November 1950
Builder: Portsmouth Naval Shipyard of Kittery, Maine
Laid down: 15 March 1952
Launched: 1 August 1953
Sponsored by: Mrs. J.E. Jowers, the widow of Chief Motor Machinist's Mate Arthur L. Stanton, lost with the second Albacore (SS-218)
Commissioned: 6 December 1953
Decommissioned: 9 December 1972
Struck: 1 May 1980
Motto:
  • Praenuntius Futuri
  • (Forerunner of the Future)
Status: Donated as a museum and memorial in Portsmouth, New Hampshire
Badge:
General characteristics
Displacement: 1240 tons light, 1540 tons full, 300 tons dead
Length: 62.1 meters (204 ft) overall, 60.9 meters (200 ft) waterline
Beam: 8.2 meters (27 ft)
Draft: 6.7 meters (22 ft)
Propulsion: Two Diesels, one electric motor
Speed:
  • Surfaced: 25 knots
  • Submerged : 33 knots[1]
Range: varied with configuration
Complement: 5 officers, 49 men
Armament: none
Launching at the Portsmouth Naval Shipyard, August, 1953

USS Albacore (AGSS-569) was a unique research submarine that pioneered the American version of the teardrop hull form (sometimes referred to as an "Albacore hull") of modern submarines. The revolutionary design was derived from extensive hydrodynamic and wind tunnel testing, with an emphasis on underwater speed and maneuverability.[2] She was the third ship of the United States Navy to be named for the albacore, a small tuna found in temperate seas throughout the world.

Her keel was laid down on 15 March 1952 by the Portsmouth Naval Shipyard of Kittery, Maine. She was launched on 1 August 1953, sponsored by Mrs. J.E. Jowers, the widow of Chief Motor Machinist's Mate Arthur L. Stanton, lost with the second Albacore (SS-218), and commissioned on 6 December 1953 with Lieutenant Commander Kenneth C. Gummerson in command.

The effectiveness of submarines in World War II convinced both the Soviets and the United States Navy that undersea warfare would play an even more important role in coming conflicts and dictated development of superior submarines. The advent of nuclear power nourished the hope that such warships could be produced. The effort to achieve this goal involved the development of a nuclear propulsion system and the design of a streamlined submarine hull capable of optimum submerged performance.

Development

Late in World War II, committees on both sides of the Iron Curtain studied postwar uses of atomic energy and recommended the development of nuclear propulsion for ships. Since nuclear power plants would operate without the oxygen supply needed by conventional machinery, and since techniques were available for converting carbon dioxide back to oxygen, submarine designers turned their attention to vessels which could operate for long periods without surfacing. Veteran submariners visualized a new type of submarine in which surface performance characteristics would be completely subordinated to high submerged speed and agility. In 1949 a special committee began a series of hydrodynamic studies which led to a program within the IS Bureau of Ships to determine what hull form would be best for submerged operation. The David Taylor Model Basin tested a series of designs. The best two—one with a single propeller and the other with dual screws—were then tested in a wind tunnel at Langley Air Force Base. The single-screw version was adopted, and construction of an experimental submarine to this design was authorized on 25 November 1950. Albacore introduced HY-80 high-strength steel (then called low-carbon HTS (High Tensile Steel)), with a yield strength of 80,000 psi (550 MPa), although this was not initially used to increase the diving depth relative to other US submarines. HY-80 remained the standard submarine steel through the Los Angeles class.[3] This ship was classified as an auxiliary submarine (AGSS-569) and named Albacore.

Evaluations

Following preliminary acceptance trials, the new submarine departed Portsmouth on 8 April 1954 for shakedown training. She began the first cycle of a career in which she experimented extensively with a given configuration and then returned to Portsmouth for extensive modifications to evaluate different design concepts, to help the Navy develop better hull configurations for future submarines. On this initial cruise, she operated out of New London, Connecticut, before sailing for Key West, Florida, to conduct operations out of that port and in Cuban waters. She returned to Portsmouth on 3 July for more than a year of trials in cooperation with the David Taylor Model Basin. Throughout these operations, she underwent repairs and modification to eliminate technical problems. It was found during these early sea trials Albacore could operate at the same maximum speed as the older modernized Guppy-type submarines with half the shaft horsepower.[4]

The submarine departed Portsmouth on 12 October 1955 and sailed via Block Island for Key West, Florida, where she arrived on 19 October 1955 to commence antisubmarine warfare evaluation and to provide target services to the Operational Development Force's Surface Antisubmarine Development Detachment. On 4 November 1955, Admiral Arleigh Burke, Chief of Naval Operations, embarked on Albacore for a brief demonstration cruise. Lord Mountbatten accompanied Admiral Burke on the cruise. On 19 November 1955, Albacore sailed for a rendezvous point off the Bahamas where she conducted special operations until 24 November 1955 and then returned to Portsmouth.

From December 1955 to March 1956, Albacore underwent stern renewal. Until this time, her propeller had been surrounded by the rudder and stern plane control surfaces. With her "new look", she resembled a blimp, with her propeller aft of all control surfaces.

Operation with her new stern configuration started in April 1956 and continued until late in the year. In May, Albacore visited New York City and participated in the television production Wide, Wide World, during which she submerged, with an underwater camera mounted on her forecastle, the first live telecast of a submarine while diving.

More tests

In November 1956, Albacore reentered the shipyard for engine conversion. She departed New London, Connecticut, on 11 March 1957, for operations out of San Juan, Puerto Rico, and Guantánamo Bay, Cuba. The submarine returned to Boston, Massachusetts, on 2 April 1957 and operated locally out of Boston and Portsmouth until entering the Portsmouth Naval Shipyard early in 1958 for an overhaul which lasted until June.

The ensuing tests emphasized sound reduction and included extensive evaluation of Aqua-Plas, a sound-damping elastic which had been applied to the ship's superstructure and tank interiors. In October 1958, her bow planes were removed to further reduce noise. The submarine ended the year with a fortnight's run to Halifax, Nova Scotia, and back to serve as a target ship for Canadian warships.

In 1959, a newly designed 14-foot propeller was installed and tested. Albacore sailed south late in May and, after operating in the British West Indies for two weeks, proceeded to Key West to serve as a target for the Surface Antisubmarine Development Detachment. After returning north, she spent much of the remainder of 1959 and most of 1960 undergoing widely varied tests for the David Taylor Model Basin. One of the more unusual consisted of evaluating a concave bow sonar dome.

Subsequent post-1959 design went into the Barbel-class submarine design of which three boats were produced.

Testing more equipment

On 21 November 1960, the ship entered the Portsmouth Naval Shipyard for a major overhaul and conversion in which she received: a new, experimental, "X"-shaped tail for increased control; 10 dive brakes around her hull, a new bow which included modified forward ballast tanks, new sonar systems, and a large auxiliary rudder in the after part of her sail. following the completion of this work in August 1961, she operated along the east coast learning the effect of her new configuration and equipment upon her capabilities and performance.

In 1962, she received a newly developed DIMUS sonar system and, on 7 December 1962, work began on her fourth major conversion which included the installation of concentric contra-rotating propellers, a high-capacity silver-zinc battery and a larger main motor. New radio equipment, BQS and BQR sonars, an emergency recovery system, and a new main ballast tank blow system were also added. After the work was completed in March 1965, Albacore prepared for deployment to Florida waters to study the results of her changes. She returned to Portsmouth on 8 October 1965 and continued to evaluate her capabilities under the new configuration. On 1 August 1966, she reentered the Portsmouth Naval Shipyard to replace the silver-zinc battery and to shorten the distance between the contra-rotating propellers—work which lasted into August 1967.

Standardization and machinery tests in the Gulf of Maine during September were followed by evaluation of towed sonar arrays off Port Everglades, Florida, in October and November. Then came acoustics trials in the Tongue of the Ocean, a deep channel in the Central Bahama Islands.

On 1 January 1968, the submarine returned to Portsmouth for a modification of her propulsion system which kept her in the navy yard until 19 April. Then, following a month of trials in the Gulf of Maine, she headed south for evaluation of her new MONOB I and AUTEC systems and of Fly-Around-Body (FAB), Phase I, equipment on Tongue of the Ocean. She returned to Portsmouth on 24 August 1968 for AUTEC deinstrumentation and installation of FAB Phase II equipment. Then, following evaluation of this new gear in the Gulf of Maine, the Albacore returned to Portsmouth on 30 September and went into reduced operating status pending the results of further studies on the feasibility of using her thereafter for further research.

The ship remained for the most part inactive until 2 February 1970 when she began an overhaul in drydock and modifications to prepare her for Project Surpass, a research and development project sponsored by the Naval Ship Research and Development Center at Carderock, Maryland. The ship left drydock on 16 April 1971, commenced sea trials on 22 July 1971, and completed them on August 1971. Early in October, she operated off Provincetown, Massachusetts, to calibrate her sonar and radar equipment.

Decommissioning, becomes historic landmark

USS Albacore (Submarine)

USS Albacore on display in Portsmouth, NH, March 2006
Location Portsmouth, New Hampshire
Built 1953
Architect Portsmouth Naval Shipyard
NRHP Reference # 89001077
Significant dates
Added to NRHP 11 April 1989[5]
Designated NHL 11 April 1989[6]

After frequent diesel engine failures had caused repeated delays in her operations, her deployment in support of Project SURPASS was canceled, and preparations for her deactivation were begun. She used the General Motors EMD 16-338 lightweight, compact, high-speed "pancake" engine. These had also been used on the Tang-class submarine, but were replaced on them due to problems, and their "pancake" engines were used as spare parts (the engines were not replaced on Albacore due to space constraints). The unreliability of the engines and lack of spares led to the decommissioning of Albacore as further cannibalized parts became unavailable.[7][8] Albacore was decommissioned on 9 December 1972 and laid up at Philadelphia, Pennsylvania. Her name was struck from the Naval Vessel Register on 1 May 1980, and she was towed back to Portsmouth late in April 1984. When being towed to a permanent display site, the Albacore became stuck in the mud of Portsmouth Harbor, and the initial attempt to move her ashore failed when the temporary marine railway built for the purpose derailed. Eventually she was floated into place using a temporary cofferdam. In 1985, she was dedicated as a memorial.

USS Albacore's final tail (2011)

Albacore's service as an active experimental submersible for more than two decades steadily increased the Navy's knowledge of both theoretical and applied hydrodynamics which it used in designing faster, quieter, more maneuverable and safer submarines. The Navy's effort to build hulls capable of optimum operation while submerged was wedded to its nuclear propulsion program in the submarine Skipjack which was laid down in the spring of 1956, and these two concepts have complemented each other in the design of all of the Navy's subsequent submarines.

Albacore is located at Albacore Park, 600 Market Street, Portsmouth, New Hampshire. She is listed on the National Register of Historic Places, and was designated a National Historic Landmark on 11 April 1989.[6][9]

See also

Other US Navy research submarines:

References

This article incorporates text from the public domain Dictionary of American Naval Fighting Ships. The entry can be found here.

  1. ↑ Tyler, Patrick (1986). Running Critical. New York: Harper and Row. p. 70.
  2. ↑ Scrafford, Julie (2006). "Albacore: Forerunner to the Future". Undersea Warfare. U.S. Navy. 8 (4). Retrieved 25 January 2011.
  3. ↑ Friedman, Norman (1994). U.S. Submarines Since 1945: An Illustrated Design History. Annapolis, Maryland: United States Naval Institute. p. 56. ISBN 1-55750-260-9.
  4. ↑ "Streamline Sub Sets Under Water Speed Records." Popular Mechanics, June 1954, p. 73.
  5. ↑ National Park Service (2007-01-23). "National Register Information System". National Register of Historic Places. National Park Service.
  6. 1 2 "USS ALBACORE (Submarine)". National Historic Landmark summary listing. National Park Service. Retrieved 2007-10-13.
  7. ↑ "The Albacore Story: Concept to Mothballs". Albacore Park. Retrieved November 21, 2016.
  8. ↑ Pierce, William. "General Motors / Electro-Motive 16-184 Diesel Engine". Old Machine Press. Retrieved November 21, 2016.
  9. ↑ Kevin J. Foster (28 July 1988). "National Register of Historic Places Registration: USS Albacore (AGSS-569)" (PDF). National Park Service. Retrieved 2009-06-22. and Accompanying 1 photo, from 1988. (124 KB)
Wikimedia Commons has media related to USS Albacore (AGSS-569).

Coordinates: 43°04′57″N 70°46′00″W / 43.082375°N 70.766737°W / 43.082375; -70.766737

This article is issued from Wikipedia - version of the 11/21/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.